If always peps any of our cars up and the run it almost to empty, I guarantee you’ll notice a difference. It’s some strong stuff bro but even Mama and Brooke can tell when I put it in there cars.

• Have you looked at the spark plugs to see if they need to be changed?
• I would check the timing before i would check the plugs just because its a little easier.
• If the mechanic looked at it and said your timing was off, why wouldnt you just have them do it??
• If always peps any of our cars up and the run it almost to empty, I guarantee you’ll notice a difference.
• Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.
• Try putting 2 or 3 bottles of „Lucas Fuel Injector Cleaner“ in there.
• Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.

No crank, no start, no power

If they are aligned, tighten the pulley and give it a shot. I would check the timing before i would check the plugs just because its a little easier. If ur car is off timing, in general, ur check engine light be on and it would idle rough. My suggestion is to eliminate the exhaust being plugged, disconnect the exhaust manifold at the point that it bolts to the down pipe. Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around. Then take it on a test drive and see if it makes a difference.

CarGurus Experts

Have you looked at the spark plugs to see if they need to be changed? Also, with the cam pulley that wobbles, check to make sure the timing marks on both cam pulleys and the crank pulley are aligned vaiyo with the timing belt. If these marks are off, it can cause BIG problems along with not starting. If the marks are not aligned, align them and then tighten down the pulley and give it a shot.

• Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.
• It’s some strong stuff bro but even Mama and Brooke can tell when I put it in there cars.
• I would check the timing before i would check the plugs just because its a little easier.
• Have you looked at the spark plugs to see if they need to be changed?
• If these marks are off, it can cause BIG problems along with not starting.
• Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.
• Try putting 2 or 3 bottles of „Lucas Fuel Injector Cleaner“ in there.
• Then take it on a test drive and see if it makes a difference.
• If the marks are not aligned, align them and then tighten down the pulley and give it a shot.

No crank, no start, no power

• Then take it on a test drive and see if it makes a difference.
• If the marks are not aligned, align them and then tighten down the pulley and give it a shot.
• If they are aligned, tighten the pulley and give it a shot.
• If always peps any of our cars up and the run it almost to empty, I guarantee you’ll notice a difference.
• Also, with the cam pulley that wobbles, check to make sure the timing marks on both cam pulleys and the crank pulley are aligned with the timing belt.
• If ur car is off timing, in general, ur check engine light be on and it would idle rough.

If the mechanic looked at it and said your timing was off, why wouldnt you just have them do it?? If you dont really have experience working on cars, imo i would have someone else switch cam pulleys and put everything back to TDC. I had the same problem and smelled gas after hard acceleration. Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up. Try putting 2 or 3 bottles of „Lucas Fuel Injector Cleaner“ in there.

CarGurus Experts

CarGurus Experts

• If you dont really have experience working on cars, imo i would have someone else switch cam pulleys and put everything back to TDC.
• If ur car is off timing, in general, ur check engine light be on and it would idle rough.
• Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.
• If these marks are off, it can cause BIG problems along with not starting.
• I had the same problem and smelled gas after hard acceleration.

No crank, no start, no power

No crank, no start, no power

Mit dem Laden des Videos akzeptieren Sie die Datenschutzerklärung von YouTube.
Mehr erfahren

Video laden

YouTube immer entsperren

CarGurus Experts

CarGurus Experts

• I would check the timing before i would check the plugs just because its a little easier.
• Also, with the cam pulley that wobbles, check to make sure the timing marks on both cam pulleys and the crank pulley are aligned with the timing belt.
• Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.
• If these marks are off, it can cause BIG problems along with not starting.
• Then take it on a test drive and see if it makes a difference.
• Have you looked at the spark plugs to see if they need to be changed?
• Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.

No crank, no start, no power

CarGurus Experts

No crank, no start, no power

CarGurus Experts

CarGurus Experts

• If these marks are off, it can cause BIG problems along with not starting.
• If ur car is off timing, in general, ur check engine light be on and it would idle rough.
• I would check the timing before i would check the plugs just because its a little easier.
• It’s some strong stuff bro but even Mama and Brooke can tell when I put it in there cars.
• Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.
• I had the same problem and smelled gas after hard acceleration.
• If the marks are not aligned, align them and then tighten down the pulley and give it a shot.